Disruptor Extreme Brushless 4s Self-Righting Speed R/C Boat (Orange)

By:traxxas
$349.99

This item is available only at our retail locations. Available exclusively at these locations. Call to confirm. In-store pricing may vary.

Quantity: Only 1 left in stock.

condition:New

UPC:020334033475

MFR:TRA106064-4-ORNG

Full-Throttle, Non-Stop Fun. The all-new 4s Disruptor® is the one boat that holds nothing back. The fun begins when you pin the throttle and Disruptor launches hard on its way to 40+MPH on a single 4s LiPo battery. At 26&Prime long, Disruptor is perfectly sized to be quick and agile on small ponds and stable in open water. Disruptor is purpose-built by Traxxas for the wildest stunts and unstoppable fun - all with Rapid Right(TM) self-righting security.

 

Rapid Right Security

There’s no need to back off the throttle or tone down the fun with Disruptor's Rapid Right security. Take full advantage of 4s Velineon® brushless horsepower anytime, anywhere. If Disruptor should land upside down, applying reverse full throttle rights the boat almost instantly and gets you back in the action.

 

Agile Handling

Disruptor’s perfectly sized hull delivers agile handling for tight turns with equally impressive 40+MPH speed. A new low-CG design concentrates weight inboard along the centerline for perfect weight distribution. Hammer the throttle and Disruptor gets on plane quickly with lightning-fast reflexes and high-speed stability.

 

New 4s Power System

The Velineon VXL-4s Marine brushless power system is a clean-slate design optimized to deliver maximum thrust on a single 4s LiPo battery. The all-new brushless outrunner motor is a model of efficiency and power, combining thunderous torque with high-RPM speed. Two independent water cooling systems keep temperatures in check for maximum run time.

 

Injection-Molded ABS Hull

Disruptor’s ABS hull provides the superior strength and rigidity required for high-voltage brushless horsepower without excess weight. The unique injection-molded design features multiple support trusses and ridges for exceptional strength. Molded bosses secure the removable electronics tray in place with minimal hardware for additional weight savings.

 

High-Performance Hull

Disruptor's 26" injection-molded ABS hull delivers incredible in a wave-cutting deep-V design. Precisely molded strake detail in the bottom hull increases Disruptor's sharp handling and stability. The hull's enhanced rigidity also provides superior hatch sealing and water rejection.

 

Sealed Clipless Hatch

Four locking nuts hold Disruptor's hatch firmly in place and release in just seconds with quick turn of the included tool. The rigid injection-molded hatch fits tightly against a foam gasket to keep water out. No matter how wild the stunts get, this hatch stays locked until you release it.

 

Water-Cooled Electronics

Dual water pick-ups under the hull send water independently to the motor and ESC. A large, finned heat sink with internal water channel cools the ESC run after run for extended fun on the water. A machined aluminum water-cooled motor mount draws heat away from the motor to keep temperatures in check.

 

Specs:

  • Boat Specs:
    • Hull Type:     Deep-V
    • Hull Length:     26.22 inches (666 mm)
    • Overall Length:     29.76 inches (756 mm)
    • Beam:     7.64 inches (194 mm)
    • Height:     5.91 inches (150 mm)
    • Deadrise:     25 degrees
    • Weight (no battery):     3.66 pounds (1.66 kg)
    • Speed Control:     VXL-4s&trade Marine electronic speed control
    • Motor (electric):     14-pole brushless outrunner
    • Cooling:     Independent dual-inlet water cooling
    • Hull Material:     Injection-molded ABS
    • Drive System:     Direct drive 0.15-inch flex cable
    • Prop:     42 mm 2-blade composite (59 mm pitch)
    • Outdrive:     Anodized aluminum
    • Steering Servo:     2056 waterproof
    • Radio System:     TQ&trade 2.4 GHz (2-channel)
    • Receiver:     6519 2.4 GHz 3-channel
    • Skill Level:     2
    • Battery Compartment (L/W/H):     180 mm long x 49 mm wide
    • Required Batteries:     4 “AA” (transmitter), Boat
  • Motor Specs:
    • Type:     14-pole brushless outrunner motor
    • Weight:     8.04 ounces (228 g)
    • Length:     2.68 inches (68 mm)
    • Diameter:     1.89 inches (43 mm)
    • Motor Shaft:     5 mm
    • Motor Connectors:     6.5 mm bullet
  • ESC Specs:
    • Input Voltage (cells):     2s-4s LiPo
    • Case Size:     3.82&Prime (97 mm) x 1.5&Prime (38 mm) x 1.5&Prime (38 mm)
    • BEC Voltage:     6.0 volts
    • Thermal Protection:     Two-stage thermal shutdown
    • Battery Connector:     Traxxas High Current Connector

 

Features:

  • 26&Prime Deep-V Hull
  • Rigid Injection-Molded Clipless Hatch
  • 40+MPH with Single 4s LiPo Battery
  • TQ&trade 2.4 GHz Transmitter
  • Rapid Right Self Righting
  • VXL-4s Marine Speed Control
  • Brushless outrunner Motor
  • Extra-Long 180 mm Battery Tray

 

Contents:

  • Disruptor 4s boat with VXL-4s Marine ESC and outrunner motor
  • Quick Start Guide
  • TQ 2.4 GHz radio system
  • Boat stand
  • Hatch nut tool
  • Maintenance tools
  • Optional hatch wingnuts

 

Required:

  • Batteries
    • Disruptor requires a 4-cell LiPo battery for maximum performance. 2 and 3-cell LiPo batteries are optional.
  • Charger
    • Traxxas EZ-Peak® Live (2971) is recommended for easy and fast charging performance.
  • AA Alkaline Batteries
    • Four AA alkaline batteries for the transmitter.

 

Used with permission, copyright © 2024 Traxxas. Copyright ©2024 Brey Corp. t/a Hobby Works.®

 

 


$6 Flat Rate Shipping. FREE Over $199* Most Orders

X