Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ should also be used. To prevent premature curing, dont spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.
Price Listed is for 1 oz. size only
Used with permission, copyright 2018 Bob Smith Industries. Copyright 2018 Brey Corp. t/a Hobby Works.
WARNING: This product can expose you to chemicals including volatile organic compounds (or VOCs), which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
$6 Flat Rate Shipping. FREE Over $199* Most Orders